SATO S84 ex - List of Initial Values; Normal Mode; User Mode

2 Operation and Configuration
17
S84-ex/S86-ex Service Manual
2.1.4 RFID Mode
The RFID mode allows user to enable RFID module if the optional RFID kit is installed. The RFID User
mode described in the operating modes in the operator manual is available only if the RFID module is
enabled.
The flowchart shows the sequence of the setting screens for the RFID mode. The table describes each
setting screen in detail.
RFID MODULE
This screen allows user to set whether or not to use the RFID function.
• ENABLE: The RFID User mode is available as one of the operating
modes.
• DISABLE: The RFID User mode is not available.
Print head open +
Press + + +
Power on
Select RFID
MODE +
button
',6$%/(
(1$%/(
button
button
button
button
',6$%/(
(1$%/(
7,0(287PV
button
Select ENABLE
+ button
Select DISABLE
+ button
* Press the , , or button to select an item or set the value
accordingly. The active arrow icons are shown on the screen.
* Pressing the button on each screen will revert to the
MAINTENANCE MODE menu.
',6$%/(
(1$%/(