SATO S84 ex - Interface Mode

2 Operation and Configuration
20
S84-ex/S86-ex Service Manual
2.2.3 Interface Mode
Setting Item Initial Value
Default Setting
(Dot Density Change)
INTERFACE AUTO SELECT DISABLE Yes
INTERFACE SETTING NO -
PORT SELECT DATA PORT Yes
DATA PORT USB Yes
SUB PORT NONE Yes
LAN
DHCP SETTING DISABLE No
IPv4 ADDRESS 192.168.001.001 No
IPv4 SUBNET MASK 255.255.255.000 No
IPv4 GATEWAY ADR 0.0.0.0 No
IPv6 RESOLUTION AUTO Yes
IPv6 ADDRESS 0:0:0:0:0:0:0:0 Yes
PREFIX LENGTH 64 Yes
DEFAULT ROUTER 0:0:0:0:0:0:0:0 Yes
PORT NUMBER1 1024 No
PORT NUMBER2 1025 No
PORT NUMBER3 9100 No
PROTOCOL STATUS5 Yes
ITEM NO. CHECK DISABLE (When STATUS5 is selected) Yes
BCC CHECK DISABLE (When STATUS5 is selected) Yes
STATUS REPLY TIMING ENQ (When STATUS4 is selected) Yes
WLAN
DHCP SETTING DISABLE No
IP ADDRESS 192.168.001.001 No
SUBNET MASK 255.255.255.000 No
GATEWAY ADDRESS 192.168.001.002 No
WIRELESS MODE Ad Hoc No
SSID SATO_PRINTER No
CHANNEL 06 No
PROTOCOL STATUS5 Yes
ITEM NO. CHECK DISABLE (When STATUS5 is selected) Yes
BCC CHECK DISABLE (When STATUS5 is selected) Yes