SATO S84 ex - Memory Mode; Advanced Mode

2 Operation and Configuration
23
S84-ex/S86-ex Service Manual
2.2.4 Memory Mode
2.2.5 Advanced Mode
Setting Item Initial Value
Default Setting
(Dot Density Change)
SLOT SETTING NO -
CARD SLOT SELECT SLOT0 RAM Yes
CARD SLOT SELECT SLOT1 FROM Yes
CARD SLOT SELECT SLOT2 SD Yes
MEMORY MODE MEMORY SIZE -
STORED CONTENTS FORM OVERLAY -
MEMORY FORMAT NO -
FORMAT START NO -
Setting Item Initial Value
Default Setting
(Dot Density Change)
PRINTER TYPE DISPENSER Yes
BACKFEED MOTION BEFORE Yes
PRINT METHOD TRANSFER (Set to DIRECT with direct
thermal model)
Yes
PITCH SENSOR ENABLE (When CONTINUOUS is
selected)
Yes
SENSOR TYPE GAP Yes
COMMAND ERROR DISABLE Yes
HEAD CHECK DISABLE Yes
HEAD CHECK NORMAL (When HEAD CHECK is
enabled)
Yes
HEAD CHECK MODE ALL (When HEAD CHECK is enabled) Yes
HEAD CHECK PAGE NO. 000001 (When CHECK PAGE is
selected)
Yes
EXTERNAL SIGNAL SETTING NO -
EXTERNAL SIGNAL ENABLE Yes
EXTERNAL SIGNAL TYPE4 Yes
EXTERNAL REPRINT DISABLE Yes