SATO S84 ex - Memory Mode; Advanced Mode

2 Operation and Configuration
21
S84-ex/S86-ex Service Manual
WLAN
STATUS REPLY TIMING ENQ (When STATUS4 is selected) Yes
IEEE1284
PROTOCOL STATUS5 Yes
ITEM NO. CHECK DISABLE (When STATUS5 is selected) Yes
BCC CHECK DISABLE (When STATUS5 is selected) Yes
RECEIVE BUFFER 1 ITEM (When STATUS4 is selected) Yes
IEEE1284 ACK SIGNAL 00.5us (When 1ITEM is selected) Yes
RS-232C
BAUDRATE 19200 Yes
PARITY BIT NONE Yes
STOP BIT 1 BIT Yes
CHARACTER BIT 8 BIT Yes
PROTOCOL STATUS5 Yes
ITEM NO. CHECK DISABLE (When STATUS5 is selected) Yes
BCC CHECK DISABLE (When STATUS5 is selected) Yes
RECEIVE BUFFER 1 ITEM (When READY/BUSY, XON/
XOFF is selected)
Yes
USB
PROTOCOL STATUS5 Yes
ITEM NO. CHECK DISABLE (When STATUS5 is selected) Yes
BCC CHECK DISABLE (When STATUS5 is selected) Yes
Bluetooth
Authentication Level NONE Yes
PIN CODE 0000000000000000 Yes
DEVICE NAME SATO_PRINTER Yes
DISCOVERY SETTING ENABLE Yes
PARAMETER SETTING(ISI) 0800 Yes
PARAMETER SETTING(ISW) 0012 Yes
PARAMETER SETTING(PSI) 0800 Yes
PARAMETER SETTING(PSW) 0012 Yes
PROTOCOL STATUS4 Yes
CRC CHECK DISABLE Yes
IGNORE CR/LF NO Yes
Setting Item Initial Value
Default Setting
(Dot Density Change)