5 Replacement
62
S84-ex/S86-ex Service Manual
4 Make sure that the UHF (short) antenna
assembly is attached onto the RFID
head cover as shown in the picture.
If not, insert front part of UHF (short) antenna
assembly through the rectangle opening of the
RFID head cover.
Route the antenna wire accordingly.
5 Attach the RFID head cover to the
new print head using two screws
(print head) .
For Americas: Standard/Right Hand and
Europe/Asia: Left Hand printer
Align the edge of the RFID head cover
carefully to the side of the print head
as
shown.
Then fix the position using the screws.
The print head assembly is known as
RFID print head assembly
in the later steps.
For Americas: Opposite/Left Hand and
Europe/Asia: Right Hand printer
Align the edge of the RFID head cover
carefully to the side of the print head
as
shown. Push the black sheet all the way to the
left edge of the rectangle opening.
Then fix the position using the screws.
The print head assembly is known as
RFID print head assembly
in the later steps.
Note
Make sure that the loop of the antenna wire is as
short as possible.
Align
Americas: Standard/Right Hand
Europe/Asia: Left Hand
Americas: Opposite/Left Hand
Europe/Asia: Right Hand
Align
(1.5 mm)
Push the black sheet all
the way to the left edge of
the rectangle opening.
12
7
11
8
13
To Next Page
Loading...
