Chapter 5 Dismantling components
178 SMSO-2-02.05- 15.07.03
5.5.9 Replace, install microswitch
For safety information see the section entitled
“Safety Regulations”
These instructions apply only to the following microswitches:
Panel switch
Brewing unit start position
Milk foamer head position
Grounds container
Door to refrigerator
Adjustment instructions
All microswitches are fastened with screws into elongated
holes, so that they can be adjusted with optimum effect.
1 Micro switch not actuated
2 Microswitch actuated at correct setting
3 Microswitch actuated, incorrect setting
4 Actuating element (shift curve)
Adjusting the microswitch
1. Loosen the fixing screw
2. Push the microswitch into the elongated hole in such a
way that the roller arm is sufficiently depressed by the
actuating element to ensure that it actuates correctly (an
audible click, plus approx. 1mm of travel). The roller arm
must not be bent!
3. Tighten the screws and repeat the switch procedure; if
necessary readjust the switch position.
To Next Page
Loading...
Need help?
General
