EasyManuals Logo

Schaerer Ambiente 2 Service Manual

Schaerer Ambiente 2
260 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #177 background imageLoading...
Page #177 background image
Chapter 5 Dismantling components
SMSO-2-02.05- 15.07.03 161
5.4.19 Power PCB
For safety information see the section entitled
“Safety Regulations, PCBs”
Preparation
Disconnect supply connections
Dismantle the left-hand side casing
1. Disconnect the supply cable (from the toroidal core
transformer / voltage stabilising circuit)
2. Pull out the connecting cable to the unit control system
from the connector shell on the unit control system
3. Label all the other plug-in connections and disconnect.
4. Push the printed circuit board holder hook outwards; the
PCB is pushed out of the holder. Remove the PCB from
the framing and place on an ESD mat!
Repair (see EKSO-2)
Electrical check
See section entitled “control system diagram”
Power supply line
Power PCB, control voltage
Power PCB, stabiliser, control voltage
Installation
Carry out assembly in reverse order to the dismantling pro-
cedure.

Table of Contents

Other manuals for Schaerer Ambiente 2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Schaerer Ambiente 2 and is the answer not in the manual?

Schaerer Ambiente 2 Specifications

General IconGeneral
BrandSchaerer
ModelAmbiente 2
CategoryCoffee Maker
LanguageEnglish

Related product manuals