7.3 Event messages
Definitions
All important scales functions are monitored internally. An event message is displayed if an
error occurs.
Details and instructions on error diagnostics can be found in the ‘Event Messages’ chapter.
Example:
Status Message E1 Mains Failure
Status messages appear in the left part of the display and are indicated by a category ID
(e.g. ‘E’) and a number (e.g. ‘1’). An explanatory text may also be called up.
Events are divided into 4 classes. The event may be allotted to a particular class by
selecting the corresponding parameter.
n
ALARM Display blinks quickly.
Totalizing switching itself off, scales not ready for service. May only
be turned on again after the cause of the problem has been removed
and the message has been acknowledged.
Acknowledgement:
The blinking will stop but the message remains if the cause of the
problem has not been rectified.
n
WARNING 1 Display blinks slowly.
Totalizer continues to function.
Acknowledgement:
The blinking will stop but the message remains if the cause of the
problem has not been removed.
n
WARNING 2 Permanent display.
Acknowledgement:
Not necessary. Once the source of the problem has been removed
the message disappears automatically.
n
IGNORE No event monitoring other than Min-Max messages from contact
outputs.
If several events occur simultaneously, the event with the highest priority will be displayed.
Priority: Alarm, Warning 1, Warning 2
Operation 7.3 Event messages
INTECONT® Satus Operating Manual BV-H2346GB / 0833 17
© Schenck Process
To Next Page
Loading...
Need help?
General
