Schenck process Intecont Satus - Index

Index
A
aborted ......................................................................26
Acknowledge ..................................................................15
Acknowledgement ..............................................................17
Acknowledgement: .............................................................17
Acknowledging Event Messages....................................................2
ADDRESS ................................................................50-51
Adjustment functions ............................................................23
ALARM ......................................................................17
alarms .......................................................................14
Analog output ...............................................................11,30
Analog output ..................................................................5
Angle a ......................................................................42
ATTENTION ..................................................................63
B
Baud rate .....................................................................51
Baud rate and bus addresses:.....................................................76
Belt circuit LB..................................................................23
Belt circuit number..............................................................43
Belt Circuit Time ...............................................................42
Belt conveyor speed ............................................................13
belt drive ...................................................................14,24
belt load ...................................................................16,55
Belt load......................................................................13
belt speed ..................................................................14,16
belt tension ...................................................................23
Binary inputs ..................................................................11
Binary outputs .................................................................11
Bit informations ................................................................62
Burden .......................................................................11
Bus addresses: ................................................................72
Bus termination..............................................................72,76
Byte sequence ..............................................................50,62
C
C1:LC input ...................................................................59
C2:Tachometer input ............................................................59
Calibrat. Results ...............................................................35
Calibration C ..................................................................59
Calibration Data .............................................................35,42
Calibration Results .............................................................43
calibration weight...............................................................26
Changing parameters ............................................................1
channel filters .................................................................69
INTECONT® Satus Operating Manual BV-H2346GB / 0833 93
© Schenck Process