1 Safety Instructions
Intended Application
The measuring system with connected mechanical components is intended solely for
weigh tasks and related control applications. Use for any other purpose is considered
to be unintended use.
Sources of Risk
If the measuring system has been correctly installed and commissioned, it does not
pose any danger during weigh operations.
Hazards may arise when the system is used for control operations or for transporting
weighed goods. Potential hazards may then arise from e.g. additional devices through
which the weighed goods are passed or metered. Minor risks may arise in these
situations if the measuring system is used or operated by untrained personnel.
The measuring system may be used as a component in a more complex system. The
system licensee is fully responsible for the operating safety of the system.
Identifying residual hazards
This symbol identifies potential hazards that could lead to injury or even death in
extreme cases.
This symbol identifies potential hazards that could result in damage to the measuring
system or other system components.
Personnel
Preparation, assembly, commissioning, operation, maintenance and servicing may
only be carried out by qualified personnel.
All persons who use the measuring system in any way must know and observe the
safety instructions and those sections of the operating manual relevant to them.
It is the responsibility of the licensee to oblige the operating personnel to comply with
all regulations and instructions as they appear in the operating manual.
Changing parameters
Parameters determine the mode of operation of the measuring system. Only
personnel familiar with the device’s mode of operation may alter these parameters
(e.g. after training by SCHENCK Process GmbH). Incorrectly set parameters may
cause injury or material damage. Furthermore they may also cause considerable
disruption to weigh operations.
Password
Passwords safeguard the parameters against unauthorized alteration. The measuring
system licensee must ensure that the password is handled responsibly.
Safety Instructions
INTECONT® Satus Operating Manual BV-H2346GB / 0833 1
© Schenck Process
To Next Page
Loading...
Need help?
General
