Schenck process Intecont Satus User Manual

Acknowledging Event Messages
Event messages may only be acknowledged once the error has been rectified.
Ensure that any connected peripheral devices are functioning correctly before
acknowledging an event. Any connected control systems in particular must be in safe
state.
Maintenance and Service
All warning and instruction signs on the scales must be observed.
The measuring system must be shut down before work is performed on mechanical
equipment or peripheral devices (control systems in particular). Steps must be taken
to ensure the measuring system cannot be started inadvertently.
The power supply must be disconnected before work is performed on electrical
equipment.
Moisture and Humidity
All scales parts, electrical components in particular, must be protected from moisture
and humidity when the housing is opened for e.g. maintenance and service. In other
respects the protection classes of the housing must be observed.
Design Modifications
Schenck Process GmbH assumes no liability or guarantee for any design
modifications made to the measuring system or additional components fitted to it that
were not supplied by Schenck Process GmbH. This especially applies to alterations
which could affect the operating safety of the measuring system.
Replacing Parts
If parts must be replaced in the course of a repair, only original spare parts from
Schenck Process GmbH may be used. The use of other spare parts will void the
warranty.
Safety Instructions
2 BV-H2346GB / 0833 Operating Manual INTECONT® Satus
© Schenck Process

Schenck process Intecont Satus Specifications

General

Brand	Schenck process
Model	Intecont Satus
Category	Measuring Instruments
Language	English