Safety and Functional Tester GLP2-i/e
During the test, test object and test leads must not be touched!
The safety measures required by law must be adhered to!
Schleich GmbH * D-58675 Hemer * 0049 / (0)2372 / 9498-0 * 0049 / (0)2372 / 9498-99 *
http://www.schleich.com * info@schleich.com 52
You can skip HV tests with the key switch for enabling the high voltage, i.e. this function allows to perform a
“subjective” spot check.
Explanation:
If the key switch is in position OFF, no high-voltage test will be performed in this process. As set value, the
result table indicates “Lock”.
If the key switch is in position ON, the high-voltage test will not be performed in this process of the test
program.
The key switch allows the user to decide, in which case a high-voltage test is to be performed.
confirm no go (only if a dual test cover is connected)
On: If a test is evaluated with no go, this “no go” test first needs to be acknowledged with the start switch,
before a new test can be started. For this time period, the “no go” LED and the “test” LED at the testing
device is blinking.
Start single test
When switching on the tester, you start with a single test. The single test that is selected here, appears on
the display, after switching on the testing device.
Contrast control
The contrast respectively the light angle of the LCD can be increased (adjusted) with the + button and
reduced (adjusted) with the - button.
To Next Page
Loading...