Schleich GLP2-i/e - 5.5.6 Printer

To Next Page

To Previous Page

Safety and Functional Tester GLP2-i/e

During the test, test object and test leads must not be touched!

The safety measures required by law must be adhered to!

Schleich GmbH * D-58675 Hemer * 0049 / (0)2372 / 9498-0 * 0049 / (0)2372 / 9498-99 *

http://www.schleich.com * info@schleich.com 55

5.5.6 Printer

Printer

Printer COM 0...........: assigned

Printer COM 1...........: assigned

Protocol number.........: off

Protocol number.........: 0000000000

Increm. Counter.........: Do not count

Print protocol..........: Without time/date

Free columns............: 0

Free lines..............: 0

Indiv. protocols........: off

Enter ?

 

- +

Printer COM0:

assigned: The interface is not enabled for a printer in the menu interfaces.

off: No printing

Test & print: The test results will be printed.

Self-test: The self-test will be printed.

Test & Selftest: Both, the test results and the result of the self-test will be printed.

Print all: The results printed after the test program has been completed. It is possible to

enter the desired number of print-outs.

Print all go: The results printed after the test program has been completed and the test is

OK (go). It is possible to enter the desired number of print-outs.

Print all no go: The results printed after the test program has been completed and the test is

not OK (no go). It is possible to enter the desired number of print-outs.

Printer COM1: