Schleich GLP2-i/e - Page 57

Safety and Functional Tester GLP2-i/e
During the test, test object and test leads must not be touched!
The safety measures required by law must be adhered to!
Schleich GmbH * D-58675 Hemer * 0049 / (0)2372 / 9498-0 * 0049 / (0)2372 / 9498-99 *
http://www.schleich.com * info@schleich.com 57
Number of lines
Here you can enter the number of lines that are to be printed on one page. After these lines have been
printed, the sheet of paper will be ejected. The following page will again be printed out with a header.
Amount print-outs.:
Hier kann ausgewählt werden wie oft das Protokoll beim Sammeldruck ausgedruckt werden soll.
Indiv. protocols
off: The printout will be on continuous paper in the form of a list.
on: Every protocol will be printed out on an individual page. As soon as a test is
completed, the page is ejected.
Character set
IBM standard CP437 (DOS Latin US) IBM symbol character set or extended Epson character set.
ISO8859-1(Win): ISO8859-1, CP1252 (WinLatin), (attention: no Ohm character).
CP850(Dos): (DOS Latin1) (attention: no Ohm character).
Only the IBM standard character set contains an Ohm character. Normally, this character set is used and
activated in the printer (handbook of the printer).
In some printer handbooks, this character set is defined as CP437 or DOS Latin US.
Printer pause:
Hier kann eine Pause nach dem Zeilenvorschub (Linefeed) eingegeben werden. Einige Serielle Drucker
können beim drucken der Zeile keine weiteren Zeichen empfangen, daher muss gewartet werden bis die
Zeile gedruckt worden ist.