SciCan STATCLAVE G4 - Page 44

44
Factory Default
Reset all values to factory
settings. DO NOT USE unless
instructed by SciCan.
NVRAM Tools
NETWORK SETUP
If your unit has access to the network but no internet, the connectivity icon on the home screen will be
yellow. You may need to manually enter a DNS value, for example: 008.008.008.008. A static IP address
may be required for some network configurations. Consult the local network’s administrator.
Network
Select Plugged in cable or WiFi
Automatic IP (DHCP)
To enable the use of a static IP
address for your unit, select OFF.
Renew IP
Use to renew the unit’s IP
address in case of a network
error. Additionally, you can scan
the QR code on this screen with
a handheld device to create an
instant Remote Access. (Device
must be on same network as
unit.)
Static IP
Enter the static IP address.
Subnet Mask
A network administrator tool.
Use if you have selected a static
IP address for the unit.
Router
A network administrator tool.
Use if you have selected a static
IP address for the unit.
DNS
A network administrator tool.
Use if you have selected a static
IP address for the unit.
PRINTER TYPE
Select serial or no printer
LOCAL CONTROL QUALITY