15
2. LOCATION AND INSTALLATION
The STATCLAVE G4 will require a support surface that is strong enough to hold the weight of a fully loaded
unit with full reservoirs (a total operating weight of 175 lbs / 79.5 kg). The space should also allow room for
the door to open correctly, for the top reservoir lids to be opened for filling and for ventilation on the right
side. Please review the installation details outlined in the section below prior to installation.
If the STATCLAVE G4 is installed in a sterilization center, the manufacturer of the sterilization center should
allow enough space at the top, back and both sides of the unit to facilitate installation, leveling, and service
access to the unit.
During installation, all consumables should have been added to the machine as appropriate. It is important to
check that this has been undertaken before starting the machine.
Use the Installation Checklist for steps to ensure proper installation of unit.
Unboxing, connecting and lifting the unit into position
Remove the packaging’s plastic handle insets.
Slide the top cover up and off the unit.
Remove the accessories box and foam packaging.
To Next Page
Loading...
