SciCan STATCLAVE G4 - Setting up Load Traceability with USER ID, PIN, and Process Enforced Usage

45
Viewing the STATCLAVE G4 from another networked device may be done at high or low resolutions.
NOTE: Select LOW if you want the screens to load faster. Default is HIGH.
Select high or low quality
TECHNICIAN TOOLS
Dealer ID
Enter the number assigned to
the dealer by SciCan
Change Password
Set a new password to limit
access to the service menu
Maintenance
Notification On/Off: Turn the
maintenance message on/off.
Schedule: Select maintenance
intervals by months or cycles.
Reset: Reset the maintenance
counter after performing the
service.
CYCLE SELECTION
Some users prefer their units to display only the most common cycles used. Press on a cycle icon to
remove it from the home screen menu. Press on the icon to reinstate it.
Select the cycle icons you wish to
display on the home screen
Setting up load traceability with USER ID, PIN, and Process Enforced Usage
The Process Enforced function keeps track of who has started and who has removed a load from your
STATCLAVE G4. It does this by prompting users to enter a PIN at the start of a cycle, when they STOP or
CANCEL a cycle, and when they REMOVE a load. Using Process Enforced does not restrict any functions, it
is simply a means of tracking whether a registered user or unregistered user was operating the unit. To use
the Process Enforced feature, you must first assign User IDs and PINs.