SCW Sentry Pro - Page 57

UserManualofIRNetworkSpeedDome
56

Figure6Ͳ39 ArmingTimeSchedule

3. SettheAlarmActionsforMotionDetection.
Purpose:
You can specify the linkage method when an event occurs. The following
contentsareabouthowtoconfigurethedifferenttypesoflinkagemethod.

Figure6Ͳ40 LinkageMethod

Checkthecheckboxtoselectthelinkagemethod.Notifysurveillance
center,sendemail,uploadtoFTP,triggerchannelandtriggeralarmoutput
areselectable.
z NotifySurveillanceCenter
Sendanexceptionoralarmsignaltoremotemanagementsoftwarewhen
aneventoccurs.
z SendEmail

Send an email with alarm information to a user or users when an event
occurs.
Note:Tosen dtheEmailwhenaneventoccurs,youneedtorefertoSection