SEA SYSTEMS
INSTALLATION AND USE MANUAL
CONTROL PANEL and PREWIRED SYSTEM STK1
For Electric and Hydraulic Lifts
MSTK12-GB
Rev.01
30/12/05
SETRONIK1 Pagina 2 di 54
INTRODUCTION
Our compliments for choosing the SETRONIK1 controller as the controller for your lift.
Please carefully read this booklet so that you will be able to understand all the qualities of
this device and its potential.
The SETRONIK1 family controllers are microprocessor-controlled controllers specially
designed for the control of 1 Speed, 2 Speeds and Variable Speed, Hydraulic and Rope
Lifts operating in APB, Simplex (up and/or down collective), Duplo and Pick-Up operation.
The STK2-PM programmer allows to set a secret Access Code, know the conditions the lift
is operating in, which and how many times failures and malfunctions have occurred,
control the lift and doors motion and modify the operating characteristics of the lift itself.
Several functions specific to a particular lift can be programmed without having to act on
the Controller wiring.
As far as the operating Diagnostics is concerned, help is provided by the failure and
malfunction indications on the Programmer displays and by the indications
supplied by the board LEDs.
Warning
Since our products are in constant evolution, all information contained in this manual can
be modified by SEA SYSTEMS without notice.
In the case of special lifts, any accessory documentation relating to additional or modified
functions is provided.
To Next Page
Loading...
