SEA SYSTEMS
INSTALLATION AND USE MANUAL
CONTROL PANEL and PREWIRED SYSTEM STK1
For Electric and Hydraulic Lifts
MSTK12-GB
Rev.01
30/12/05
SETRONIK1 Pagina 7 di 54
2.1.GENERAL NOTES
NOTE
Carefully read any warning information in the present operating instructions as
holding important safety, operating and service instructions.
• Installation and service to be carried out in compliance with regulations in force,
according to the manufacturer specifications and by authorised, trained and qualified
personnel only.
• A wrong installation or an improper service could lead to damages to people, animals
or objects, which the manufacturer is not liable for.
• Should the machine be sold or transferred to a different owner, check that the present
operating instructions are always available, as to be duly used by the new owner or
operator.
• Hereby listed documents are to be sued for a correct installation set-up:
-Installation project drawing (not supplied by Sea);
-Control Panel STK1: Installation and Maintenance Manual (this manual);
-Control board programming and troubleshooting operating instructions;
-Control Panel electric wiring;
-Control Panel Installation electric wiring (in this manual).
•The installation manager must store any enclosed documents in a safe place, within
reach, thus providing for a correct lift set-up and service. Operating instructions are an
integral part to the installation and therefore they are not allowed to be damaged. Avoid
tearing pages and when consulted, it is necessary to avoid damaging to provide for any
possible future correct reference.
• Guarantee terms are on the product transportation document back. SEA SYSTEMS
will support its products through the guarantee, in case of defects with a specified time
period. Should the product not be correctly operated or its performance anyhow modified,
differently from factory original specifications, the guarantee no longer applies.
• When necessary, get in touch with the company Service Department always
providing for the installation serial number.
The serial number is specified:
- on the adhesive label on the outside of the control board unit;
- On the first page of the board electric wiring;
- On the Control board programming paper
- On the Board Declaration of Conformity
• The serial number is to be always specified to identify the installation technical
specifications.
The safety department address and telephone number are available on the present
operating instructions cover.
To Next Page
Loading...
