SEA SETRONIK1 - Setting Customer Secret Access Code

SEA SYSTEMS
INSTALLATION AND USE MANUAL
CONTROL PANEL and PREWIRED SYSTEM STK1
For Electric and Hydraulic Lifts
MSTK12-GB
Rev.01
30/12/05
SETRONIK1 Pagina 27 di 54
3.3.PROGRAMMING THE CUSTOMER SECRET ACCESS CODE.
1. Set Parameter Code 0.10 on displays DG0,DG1,DG2 .
DG0 DG1 DG2 DG3 DG4 DG5 DG6
0 1 0
ACCESS CODE
The old access code stored is displayed. If no code has been entered, value 0000 is
displayed.
Enter the new access code on displays DG3..DG6.
(Value 0000 removes the access code)
2. Set Parameter Code 0.11 on displays DG0, DG1, DG2.
DG0 DG1 DG2 DG3 DG4 DG5 DG6
0 1 1
ACCESS CODE
Enter the same access code entered in point 2 on displays DG3..DG6. If the code is
different, the same is not accepted, therefore the old code previously stored, if any, is
valid.
(Value 0000 removes the access code)
3. Perform the storing. (Please refer to the Par.3.4_Parameters Storing).