Mobile phone system* 73
Operating RADIO, MEDIA (audiovisual
systems)
NAME, TEL NAV, INFO CAR, SETUP
Requirements for using the telephone
• The vehicle must be fitted with a mobile phone adapter ⇒ page 68.
• A mobile phone has been connected to the mobile phone adapter
⇒ page 70 or
• A Bluetooth connection exists between the Bluetooth mobile phone and
the on-board phone system, and the ignition is switched on ⇒ page 71.
The telephone functions described in this chapter depend on the following:
• The telephone used must be compatible with the mobile phone adapter
and it must support the telephone functions described.
• The mobile network service provider must support the telephone func-
tions described.
After switching off the ignition, the telephone system will remain in standby
mode for about 30 minutes (shutdown delay
5)
) if the phone is left in the
adapter.
Note
• For technical reasons, mobile phones may be temporarily affected by
interference. Please refer to the instructions for your mobile phone for more
information.
• The range of the handset may be affected in isolated areas (such as a
tunnel or underground garage).
• Some places have no range at all. You will not be able to use the tele-
phone in these places.
• The activated audio source is muted during a phone conversation.
• The basic functions of the telephone can be operated using the multi-
function steering wheel* only if the telephone equipment was installed at the
factory.
• For more information about the functions of the multi-function steering
wheel*, please refer to ⇒ page 12.
PIN Code (Personal Identification Number)
– Press the function button.
– Enter the PIN code using the alphanumeric keyboard and confirm
with OK.
The PIN message displayed in the status line indicates that you must enter
your PIN code. You receive the PIN code from your mobile network service
provider together with the SIM card.
You can also enter the PIN code using the speech control system and the
command Enter PIN or Enter PIN code ⇒ page 73 or using the keypad of your
mobile phone.
The alphanumeric keyboard will be displayed automatically when the PIN
code is to be entered in the telephone menu. This will be the case, for
example, when you switch on the mobile phone.
The SIM card will automatically be blocked if you enter the PIN code incor-
rectly 3 times
6)
. The SIM card can be unblocked with the PUK (personal
unblocking key).
Note
• When you enter the PIN code the digits appear as * in the display.
• The PIN symbol may not always be shown in the display (depends on type
of mobile phone).
• Depending on your type of mobile phone, you may need to enter the PIN
code at the phone. In this case, no message will appear in the display indi-
cating that you need to enter the PIN code.
5)
You can have the shutdown delay changed by a Dealer or Qualified workshop.
6)
The total number of times you can enter the PIN code may vary depending on your type
of SIM card
TEL
media_systemE_EN.book Seite 73 Montag, 21. September 2009 1:48 13