Secutron MR-2306-DDR

72
Configuration
Command Menu-->Dialer Config
11.11.2Telephone Line
Figure 45 Telephone Line menu
Command Menu/Dialer Config/Account Info
6.Account# 2 Reporting Format
[X] Contact ID-Def
[ ] SIA 300 Baud
[ ] SIA 110 Baud
Same as Account#1.
Command Menu/Dialer-Config/Telephone
Line
1. Line#1 Dialing Type
[X] DTMF Dial->Def
[ ] Pulse Dial
Set the dialing type for line #1; this
is the type recognized or preferred
by the telephone company.
Command Menu/Dialer-Config/Telephone
Line
2. Line#2 Dialing Type
[X] DTMF Dial->Def
[ ] Pulse Dial
Same as Line#1.
Command Menu/Dialer-Config/Telephone
Line
3. Line#1 wait for Dial tone
[X] ENABLE ->Default
[ ] DISABLE
Use this function to let the system
know whether or not to wait for a
dial tone before dialing. Cell phone
setup for the dialer requires that
the system not wait for dial tone
before dialing.
Command Menu/Dialer-Config/Telephone
Line
4.Line#2 wait for Dial tone
[X] ENABLE ->Default
[ ] DISABLE
Same as Line#1.
ACCNT#2 Format:
[X] Contact ID
1 Line1 Dialtype
2 Line2 Dialtype
3 Line1 Dialtone
4 Line2 Dialtone
- Telephone Line -
5 Num of Retries
Line#1 Dialing Type:
[X] DTMF Dial
Line#2 Dialing Type:
[X] DTMF Dial
Line#1 Wait Dialtone
[X] ENABLE
Line#2 Wait Dialtone
[X] ENABLE