77
Configuration
11.12.1Dialer Test Messages
The following messages will display during the test processes of Lines #1 and #2. The
messages that will appear depend on the status of the dialer and the test results that are
found.
The dialer is checking the line for voltage. This
message automatically displays when Manual Test is
selected.
No DC line voltage. The line is dead or no phone line is
connected.
The dialer is waiting for a dial tone.
This message may indicate a noisy telephone line.
The dial tone was received and telephone number
dialing is in process.
This message indicates that the dialer failed to send a
DTMF tone.
Waiting for availability of the receiver. The receiver
confirms the availability by sending an ack tone.
This message indicates that either the telephone
number may be wrong or the receiver is not available.
When sending events to the receiver, the display will
toggle between this message and “Waiting for Kissoff“
for all events sent.
The dialer is waiting for the kissoff tone. The kissoff
tone indicates that the receiver has received the event
reports.
No Kissoff means receiver has not received any event
reports.
To Next Page
Loading...
Need help?
General
