10C
52
15.1.9 Enabling/Disabling Advanced Noise Control™
Voice Prompt
“Noise control”
Factory Default Enable
Enable Tap the Phone Button
Disable Tap the Jog Dial
When Advanced Noise Control is enabled, the background noise is
reduced during an intercom conversation. When it is disabled, the
background noise is mixed with your voice during intercom.
Note:
If you use your 10C with the Bluetooth Audio Pack for GoPro, you can
enable or disable this feature only during Normal Audio Recording Mode.
This feature is automatically disabled while in Ultra HD (UHD) Audio Mode.
15.1.10 Delete All Bluetooth Pairing Information
Voice Prompt
“Delete all pairings”
Factory Default N/A
Execute Tap the Phone Button
To delete all Bluetooth pairing information of the 10C, rotate the Jog
Dial until you hear a voice prompt, “Delete all pairings”, and tap the
Phone Button to conrm.
15.1.11 Remote Control Pairing
Voice Prompt
“Remote control pairing”
Factory Default N/A
Execute Tap the Phone Button
To enter into Remote Control Pairing mode, rotate the Jog Dial until you
hear a voice prompt, “Remote control pairing”. Then press the
Phone Button to enter into Remote Control Pairing mode. The headset
will automatically exit from the conguration menu. Please refer to
section 16, “REMOTE CONTROL”
for details on remote control.
To Next Page
Loading...
Need help?
General
