Sencore MRD 5800 - Page 102

MRD 5800 – User Manual
Page 102 (116)
576i x 544 (4x3 or 16x9) @ 25hz
480i x 720 (4x3 or 16x9) @ 29.97Hz
1080p60 License Adds –
1080p x 1920 (16x9) @ 50, 59.94 and 60Hz
SDI (Serial Digital Interface) Video
Out –
SDI Standards:
Base Unit –
SD-SDI ANSI/SMPTE S259M
HD 4:2:0 License (MRD 58710) or HD 4:2:2 License
(MRD 58720) Adds –
HD-SDI ANSI/SMPTE 292M
1080p60 License (MRD 58740) Adds –
3G-SDI Level A ANSI/SMPTE 424M
Connector:
75Ω Female BNC
Return Loss:
≥15 dB, 5Mhz to 1.5GHz
≥10 dB, 1.5 GHz to 3.0GHz
Drive Level:
800 mVpp ±10%
Data Bit Rate:
3G-SDI – 3.0 Gb/s
HD-SDI – 1.5 Gb/s
SD-SDI – 270Mb/s
Display Modes:
HD – Pillarbars, Cropped, Anamorphic
SD – Letterbox, Cropped, Anamorphic
Simultaneous SDI (Serial Digital
Interface) Video Out –
SDI Standards:
Option Card –
SD-SDI ANSI/SMPTE S259M
Connector:
75Ω Female BNC
Return Loss:
≥15 dB, 5Mhz to 1.5GHz
Drive Level:
800 mVpp ±10%
Data Bit Rate:
SD-SDI – 270Mb/s
Display Modes:
16x9 – Pillarbox, Center-Cut, Anamorphic
4x3 – Letterbox, Center-Cut, Anamorphic
Composite Video Out –
Video Format Standards:
SMPTE 170M-2004, NTSC, PAL-B/G/I/D/M/N
Connector:
Return Loss:
One 75 Ω ±10% Female BNC (CVBS)
>25dB, 0 to 6.00 MHz
Frequency Response:
Drive Level:
Chroma/Luma Delay:
Field Time Distortion:
Line Time Distortion:
Short Time Distortion:
Differential Gain:
Differential Phase:
Signal to Noise Ratio:
K factor
± 0.7dB From 0 to 4.00MHz
140 IRE (1.0Vpp), ±2 IRE
±26 ns Max
< 2% (± 3 IRE)
< 1% (± 1 IRE)
< 2% (± 3 IRE)
< 4%
< 1.5° degrees
≥55dB luminance weighted
< 2.5%
Digital Video Out –
Digital Video Standard:
SDA-HDMI-OM-E Rev A
Connector:
HDMI-type Female Type-A