Sencore MRD 5800 - Page 103

MRD 5800 – User Manual
Page 103 (116)
Audio Decoding Features
Number of Audio Services:
Base Unit –
4 Audio Services
8 Audio Service Decode License (MRD 58880) Adds –
4 Audio Services (8 total)
Audio Codecs Supported:
Dolby Digital (AC-3) & Plus (EAC-3) AAC-LC, HE-AAC,
& HE-AACv2
MPEG1L2 & MPEG2L2
Linear PCM & Dolby E (Pass-through)
Output Formats:
Digital Pass-through
PCM (Decoded Discrete channels for 5.1 Sources or
Downmixed for 5.1 Sources)
Analog (Decoded Discrete channels for 5.1 Sources or
Downmixed for 5.1 Sources)
Audio Output Features
AES Outputs –
8x 75Ω BNC AES3/EBU Unbalanced
Analog Outputs –
Output Type:
Balanced, 2 channel pairs (+/-, L/R)
Connector:
2x High density 15-pin D-sub, male
Impedence:
<100Ω Nominal Output Impedance
Max Output Level:
+24dBu @ 0dBFs
Adjustable down to +10dBu by 0.5dB steps.
Conditions For Measurements
≥600Ω Load Impedance
–20dBFS encoded TS source
Output level is adjusted to +4 dBu @ -20 dBFS
THD+N:
Dynamic Range:
< 0.015% from 20 Hz to 20khz @ +24dBu
104 dB
Signal to Noise
80 dB
Crosstalk:
< -80dB from 20Hz to 20kHz
Frequency Response:
±0.5dB 20Hz to 20kHz,
Optional Breakout Cables:
4x XLR Breakout Cable (MRD_AUD_OPT_XLR)
4x BNC Breakout Cable (MRD_AUD_OPT_BNC)
1x Terminal Block (MRD_AUD_OPT_TERM)
SDI Embedded Audio Output
Standards:
Density:
Sampling Frequency:
SMPTE 272M (for SD-SDI)
SMPTE 299 (for HD-SDI)
8 Audio Pairs
48 kHz
Ancillary Data Support
SDI VANC Data Types:
AFD (SMPTE 2016)
Closed Captions (CEA-708)
OP-47 (SMPTE RDD-08)
SMPTE RDD-11
TVG2X, AMOL-48/96 (SCTE-127)
Teletext/WSS/VPS (SMPTE-2031)
Time Code (SMPTE 12M-2)
SMPTE2038
Source ID
SCTE104 (SMPTE 2010)