Startup
7.3 Parameterizing the device
SENTRON PAC4200
System Manual, 09/2009, A5E02316180B-02
103
7.3 Parameterizing the device
7.3.1 Procedure
Procedure for parameterizing
To start up the device, you must specify the operating parameters listed below in the device
settings:
● Connection type
● Voltage
– Direct measurement on the system or using voltage transformers
– Measuring input voltage in the case of direct measurement on the system
– Primary and secondary voltage when measuring using voltage transformers
● Current
– Primary and secondary current
The following settings are also useful:
● Language
● Time zone, change to summertime
● Password protection
See also
Password management (Page 159)
7.3.2 Language
Setting the language
Set the language in which the display text is to appear.
The available languages are displayed:
● at initial startup,
● after resetting to factory settings, and
● after updating the firmware.
To Next Page