Parameterizing
9.2 Parameterizing the operator interface
SENTRON PAC4200
System Manual, 09/2009, A5E02316180B-02
163
Requesting a new password
Please have the following information to hand when phoning or provide it in writing:
● MAC address of the device.
● You can find the MAC address under "SETTINGS > COMMUNICATION"
NOTICE
Change password immediately on receipt
As soon as you receive the new password, you must change it and inform the group of
authorized users.
9.2.12 Expansion modules
Calling the device settings
Device settings for expansion modules operated with SENTRON PAC4200.
Call: "SETTINGS > EXPANSION MODULES".
See also
Configuring the PAC RS485 expansion module (Page 163)
Configuring the SENTRON PAC 4DI/2DO expansion module (Page 165)
9.2.13 Configuring the PAC RS485 expansion module
When the PAC RS485 expansion module is mounted on the SENTRON PAC Power
Monitoring Device, you can make the configuration settings for the PAC RS485 expansion
module on the Power Monitoring Device.
NOTICE
Interrupted communication when the nodes on the bus are configured differently
If the nodes on the bus are configured differently, communication faults will occur on the
bus. Ensure that for all nodes on the bus, the same baud rate, the same settings, the same
protocol and the same response time are set on the bus and on the master.
To Next Page
Loading...