Description
3.13 Slots
SENTRON PAC4200
52 System Manual, 09/2009, A5E02316180B-02
Addressing the target devices
The following address information is required in the software in order to address a device via
the gateway of SENTRON PAC4200:
● IP address of SENTRON PAC4200
● Gateway port
– Port 17002 if the RS485 bus is connected to the "MOD1" slot
– Port 17003 if the RS485 bus is connected to the "MOD2" slot
● Bus address of the target device, e.g. MODBUS address
Further information
You will find further information at:
Modbus.org "MODBUS MESSAGING ON TCP/IP IMPLEMENTATION GUIDE".
See also
Modbus IDA (http://www.Modbus-IDA.org)
3.13 Slots
Battery compartment
The battery compartment of the SENTRON PAC4200 is accessible from the outside without
opening the housing.
To Next Page