Parameterizing
9.2 Parameterizing the operator interface
SENTRON PAC4200
System Manual, 09/2009, A5E02316180B-02
159
NOTICE
Access protection is switched off
Resetting to the factory defaults deactivates device protection. Password protection is
switched off. The password is set to the value "0000".
NOTICE
Counter reset
Resetting to the factory defaults causes all counters to be reset as well!
COMMUNICATION PARAM. Resets the entered TCP/IP address to:
0.0.0.0
EXECUTE Reset function. Resets the selected value
groups.
9.2.11 Password management
Default password
The default password is: 0000
If no user-specific password has been assigned, the default password must be entered when
password protection is switched on.
9.2.11.1 Calling password management
You can find password management in the device settings under
"ADVANCED > PASSWORD"
To Next Page
Loading...