3. Select the data transfer function on the transmitter.
ISHIFT I IOPTION I
Note: To transfer one data item, display the data item to be trans-
ferred and press
ISHIFT I IOPTION I.
4. Perform data transfer.
* If the amount of memory available in the receiver at the time of data
transfer is insufficient, an error message appears. Delete any unneces-
sary data, verify that there is sufficient memory available, and repeat
the procedure.
Transferring data from an EL series Organizer
1. Select the mode on the receiver.
2. Select the data transfer function on the receiver, and set the receiver
in the receive mode.
3. Perform data transfer from the transmitter.
95
To Next Page
Loading...
