SICK C4000 Micro

Chapter 12 Operating Instructions
C4000 Micro/Basic/Basic Plus/Eco
68 © SICK AG • Industrial Safety Systems • Germany • All rights reserved 8009423/YT79/2016-03-14
Subject to change without notice
Annex
12.4 List of illustrations
Fig. 1: Components of the C4000................................................................................. 12
Fig. 2: Protecting hazardous points with a safety light curtain C4000.......................... 13
Fig. 3: Hazardous area protection with a safety light curtain C4000............................ 13
Fig. 4: Access protection using a safety light curtain C4000........................................ 13
Fig. 5: Outline drawing of the protective operation ....................................................... 14
Fig. 6: Status indicators of the sender.......................................................................... 17
Fig. 7: Status indicators of the receiver ........................................................................ 18
Fig. 8: Safety distance from the hazardous point ......................................................... 20
Fig. 9: Minimum distance to reflective surfaces ........................................................... 22
Fig. 10: Graph, minimum distance from reflective surfaces ........................................... 22
Fig. 11: Unwanted influencing of a 2nd C4000 system. ................................................. 23
Fig. 12: Reversing the transmission direction of systems in close proximity. ................. 23
Fig. 13: The correct installation (above) must eliminate the errors (below) stepping
behind, reaching below and reaching above...................................................... 24
Fig. 14: Composition of the swivel mount bracket .......................................................... 25
Fig. 15: Mounting sender and receiver using swivel mount brackets ............................. 26
Fig. 16: Composition of the side bracket ........................................................................ 27
Fig. 17: Mounting the C4000 with side bracket.............................................................. 28
Fig. 18: Pin assignment system connection C4000 Basic (M26 × 6 + FE)...................... 31
Fig. 19: Pin assignment system connection C4000 Eco (M12 × 4 + FE)......................... 31
Fig. 20: Pin assignment system connection C4000 Micro/Basic Plus
(M12 × 7 + FE).................................................................................................... 32
Fig. 21: Connecting the contact elements to the EDM.................................................... 33
Fig. 22: Connection of the reset button on the C4000 Micro/Basic............................... 34
Fig. 23: Connection of the sender test button................................................................. 34
Fig. 24: Switching example for C4000 Basic on UE48-20S ............................................ 35
Fig. 25: Switching example for C4000 Micro/Basic on UE10-30S.................................. 36
Fig. 26: Daily checks of the protective device................................................................. 39
Fig. 27: Time sequence diagram of the start-up configuration ....................................... 41
Fig. 28: Dimensional drawing C4000 Basic/Basic Plus/Ecosender (mm)...................... 51
Fig. 29: Dimensional drawing C4000 Micro sender (mm) .............................................. 52
Fig. 30: Dimensional drawing swivel mount bracket (mm) ............................................. 53
Fig. 31: Dimensional drawing, side bracket (mm)........................................................... 53
Fig. 32: Dimensional drawing deflector mirror PNS75 (mm)........................................... 54
Fig. 33: Dimensional drawing deflector mirror PNS125 (mm) ........................................ 55