SICK DUSTHUNTER T - Page 519

(3) Multi Port Setup
1) How to use Multi Port
Set up DIP switch of Multi Part Board properly.
Apply Set-up Program (SETUP.EXE) to prepare MULTICOM.CFG used by Multi Port
Driver (MULTICOM.EXE)
MULTICOM.EXE should be executed before D/L(FEP) program starts.
2) Description of DIP Switch
Set-up method of DIP switch on Multi Port Board depends on version and number
of board installed. (It is independent of number of port). Switch locations are as
follow.
[MULTI-8J VER 5.1]
Switch Name & its Function
A. 2 DIP SWITCH TYPE(VERSION 5.1)
-. SW1: MODE / BASE ADDRESS
-. SW2: IRQ Number
B. 3 DIP SWITCH TYPE(VERSION 5.0)
-. SW1: MODE / BASE ADDRESS
-. SW2: POLL ADDRESS
-. SW3: IRQ Number
C. MODE : SW1 – 1,2
D. BASE ADDRESS : SW1 – 3~8
E. IRQ Number : SW2(VER 5.1) or SW3(VER 5.0)
-. 1 à IRQ 9 -. 5 à IRQ 7
-. 2 à IRQ 3 -. 6 à IRQ 10
-. 3 à IRQ 4 -. 7 à IRQ 11
-. 4 à IRQ 5 -. 8 à IRQ 12