1) How to prepare MULTICOM.CFG
Power off D/L program according to normal procedure.
Change drive C at DOS Ex) A:\> C: Enter
Change director as TKWORK Ex) C:\> CD TKWORK
Execute TUP.EXE Ex) SETUP Enter
Input DIP switch on the Multi Port Board following set-up.
Ex) Below figure shows installation of MULTI-8J (Base:580, IRQ:10) with 1
st
Board
and MULTI-4J(Base:5C0, IRQ:11) with 2
nd
Board.
Å Save and Close. [Esc à Y]
Æ Execute D/L Program by Warm Boot (Ctrl + Alt + Del)
Ç With proper Set-up, ‘ m’ could be checked as many as total amount of port at
execution message of MULTICOM driver. (It could be viewed for a moment before
D/L program starts, refer to the picture below)
MULTICOM device driver ver x.x xx/xx/xx
Copyright(c) SystemBase Co. Ltd. Tel(xx)xxx-xxxx
BOARD NO IRQ NO BOARD ADDR PORT STATUS
=====================================123435678==
1 10 580 000000000
2 11 5C0 0000
================================================
To Next Page
Loading...
