SICK EtherNet/IP microScan3 - Page 170

Version number Amendments and new functions EtherNet/IP: Minor Revi‐
sion
V 1.2.0
•
D
eviating multiple sampling after
object detection can be config‐
ured
•
Collision protection field
•
Speed-dependent monitoring
case switching
•
Assembly 105
•
Interfaces and selected functions
can be activated or deactivated
•
According to the current specifi‐
cations for CIP Safety, only the
extended format is supported, but
no longer the base format
•
Up to 4 simultaneous monitoring
case tables
•
New Always ON (NON-safe) function
in monitoring case tables
4
Revision
T
he different revision statuses of the devices are identified by “Rev” followed by a three-
digit version number. New devices have a label which indicates the revision status.
Table 39: Revision
Version number Amendments and new functions
Rev 1.0.0
•
F
irst released version
Rev 1.1.0
•
Int
ernal change to components, no change in function
Rev 1.2.0
•
Internal change to components, no change in function
Rev 1.3.0
•
Data output: Accuracy of angle specification improved
•
Adaptation of detection behavior for optimized safety and avail‐
ability
Rev 1.4.0
•
Int
ernal change to components, no change in function
Rev 1.5.0
•
Internal change to components, no change in function
Rev 1.6.0
•
Internal change to components, no change in function
In some cases, new system plugs are not suitable for older devices.
N
ew system plugs have a label which indicates the devices for which they are suitable.
Table 40: Compatibility
Label on the device Label on the system plug Compatible
– – Yes
– Only compatible with Rev ≥1.1.0 Information is available
from your SICK subsidiary.
Rev 1.1.0 (or higher) – Yes
Rev 1.1.0 (or higher) Only compatible with Rev ≥1.1.0 Yes
13 TECHNICAL DATA
170
O P E R A T I N G I N S T R U C T I O N S | microScan3 – EtherNet/IP™ 8020200/1NTM/2024-06-03 | SICK
Subject to change without notice