3 The safety output only switches back to the ON state when the operator presses
t
he reset pushbutton, which is outside the hazardous area. If there is an object in
the protective field when the reset pushbutton is pressed, the safety output stays
in the OFF state.
4 After the reset, the operator can restart the machine in a second step.
Figure 42: How the restart interlock works (1):no one in protective field, machine operates
Figure 43: How the restart interlock works (2):person detected in protective field, safety output
in OFF s
tate
PROJECT PLANNING 4
8020200/1NTM/2024-06-03 | SICK O P E R A T I N G I N S T R U C T I O N S | microScan3 – EtherNet/IP™
65
Subject to change without notice
To Next Page
Loading...
