SICK FLOWSIC600-XT

Repairs
FLOWSIC600-XT · Service Manual · 8019179/V0-2/2016-03 · © SICK Engineering GmbH 41
Subject to change without notice
3.5.5.4 Fit the electronics cover
1 Position the electronics cover.
2 Lead the cable of the external power
supply through the recess in the
cover.
Make sure the cable is not crimped.
3 Tighten the 4 screws of the electron-
ics cover with a T20 Torx key.
4 Connect the display unit again and close. → p. 34, §3.5.1.4.