For your safety
14 © SICK AG · Division Auto Ident · Germany · Subject to change without notice 8013796/UL20/2010-09-27
Operating Instructions
Laser Measurement Systems of the LMS500 Product Family
Chapter 2
2.4 Quick stop and Quick restart
2.4.1 Switching off the LMS
Switch off voltage supply (power supply) for the LMS or disconnect the system plug on
the LMS500 or the M12 supply cable on the LMS511.
The LMS retains parameters stored in the internal, non-volatile memory. Measured values
on the interface are lost.
2.4.2 Switching back on the LMS
Switch on voltage supply (power supply) for the LMS or re-connect the system plug on
the LMS500 or the M12 supply cable on the LMS511.
The LMS re-commences operation with the parameters last saved.
2.5 Environmental protection
The LMS has been designed to minimise environmental impact. It uses only a minimum of
power.
While working, always act in an environmentally responsible manner. For this reason please
note the following information on disposal.
2.5.1 Power consumption
• The LMS500 consumes a maximum of 24 W in operation.
• In addition, the LMS511 draws a maximum of 50 W in cycles for the heating.
2.5.2 Disposal after final de-commissioning
Always dispose of unserviceable or irreparable devices in compliance with local/
national rules and regulations on waste disposal.
Dispose of all electronic assemblies as hazardous waste. The electronic assemblies are
straightforward to dismantle.
Important SICK AG does not accept unusable or irreparable devices that are returned.
To Next Page
Loading...
Need help?
General
