3
Green
4‘
LEDs on the control panel
Control panels
T
he ML
G-2 Prime and its outputs can be configured for specific applications using the
membrane keys on the control panel. Depending on the device type, a range of func‐
tions can be set in this manner (see "Configuration with the control panel", page 37).
In addition, the teach-in process for the MLG-2 can be started by pressing the Teach
pushbutton.
Figure 15: MLG-2 Prime control panel with switching outputs
Figure 16: MLG-2 Prime control panel with analog outputs and switching output
The ML
G-2 control panel can be locked to prevent incorrect operation. The lock can be
activated and deactivated using IO-Link or the pushbuttons on the control panel.
Locking the control panel
b
Pre
ss the Teach (Set) pushbutton for 15 s.
✓
The control panel is locked; the configuration cannot be changed.
✓
If a pushbutton is pressed on the control panel, the LED L2 lights up briefly.
Disabling the lock
b
On the MLG-2 Prime, press the Menu and Set pushbuttons simultaneously for 15 s.
✓
The lock is disabled again.
3 P
RODUCT DESCRIPTION
24
O P E R A T I N G I N S T R U C T I O N S | MLG-2 Prime 8018715.16YM / 2020-02-13 | SICK
Subject to change without notice
To Next Page
Loading...
