Figure 26: Mount QuickFix bracket to a profile frame
Mount QuickFix bracket to the back of a device column
NOTE
The Q
uickFix bracket has cable routing. Depending on the installation, the cable routing
can make mounting easier.
The sender and receiver are each mounted with two QuickFix brackets.
The Q
uickFix bracket consists of two parts, which are pushed into each other. An M5
screw is used to join both parts and to clamp the housing (sender or receiver).
You need two M5 screws per bracket if mounting them on the back.
b
Choose the length of the M5 screw such that it is possible to clamp the housing
(sender or receiver) in the QuickFix bracket.
4.3.2 Mounting the FlexFix bracket
In the FlexFix bracket, sender and receiver can be flexibly rotated by ±15°.
F
le
xFix brackets can be mounted in two ways:
•
On the side
•
On the back
Mounting the FlexFix bracket on a profile frame
The sender and r
eceiver are mounted at the designated points using two FlexFix brack‐
ets in each case.
M5 screws are inserted through the FlexFix bracket and into the machine or profile
frame for mounting. A screw nut or threaded hole is required on the machine or profile
frame.
4 MOUNTING
30
O P E R A T I N G I N S T R U C T I O N S | MLG-2 Prime 8018715.16YM / 2020-02-13 | SICK
Subject to change without notice
To Next Page
Loading...
