7 Operating the MLG2 Prime
7.1 Configuration with the control panel
The MLG-2 has a control panel on the receiver which is used for teaching in, alignment,
and confi
guration. The control panel is located on the connection side of the receiver.
Figure 33: Control panel with LEDs and membrane keys
1
Control panel with LEDs and membrane keys
Different control panels are available depending on the type of outputs.
Figure 34: of the MLG-2 Prime with switching
outputs
Figure 35: MLG-2 Prime control panel with ana‐
log out
puts and switching output
7.1.1 Basic operation
The functions of the two control panels are essentially the same:
•
The le
ft-hand row of yellow LEDs represents the operating level and the outputs.
•
The right-hand row of green LEDs represents the functions.
•
You select the output settings on operating level 1 and the system settings on
operating level 2.
Ö
•
A f
la
shing LED indicates that the output or function is preselected.
O
OPERATING THE MLG2 PRIME 7
8018715.16YM / 2020-02-13 | SICK O P E R A T I N G I N S T R U C T I O N S | MLG-2 Prime
37
Subject to change without notice
To Next Page
Loading...
