If you do not want to use the alignment aid every time the device is switched on, you
can de
activate it again later.
NOTE
The di
gital and analog outputs are deactivated when the alignment aid is active.
Cross-beam function
The cross-beam function increases the measurement accuracy and enables the detec‐
tion of smaller objects (see "Minimum detectable object with cross-beam function ",
page 20).
NOTE
The cr
oss-beam function only affects the object detection function, not the measure‐
ment functions.
7 OPERATING THE MLG2 PRIME
46
O P E R A T I N G I N S T R U C T I O N S | MLG-2 Prime 8018715.16YM / 2020-02-13 | SICK
Subject to change without notice
To Next Page
Loading...
