SICK OD2000 User Manual

Parameter Value Factory settings
IN Hold function Measured value
Peak value
Lowest value
Peak-to-peak value
Auto peak value
Auto lowest value
Average value
Normal
Measured value
7.4.5.3 IN Debouncing menu
When debouncing is activated, the input signal must be constantly present at the
IN Input for 100ms. The timing tolerances of the external teach functions take into
account activation and deactivation of the debounce function. It is not necessary to
adjust the timings.
Setting the IN Debouncing
> IN Input > > IN Debouncing> > Select option >
Parameter Value Factory setting
IN Debouncing No
Yes
Yes
7.4.5.4 IN Input logic menu
The behavior of the input can be selected as normally open contact (High-active, factory
setting) or normally closed contact (Low-active).
Setting the IN In Input logic
> IN Input > > IN Input logic > > Select option >
Parameter Value Factory setting
IN Input logic High-active
Low-active
High-active
7.4.6 Device menu group
7.4.6.1 Reset the device
The device can be reset to the factory settings or to saved customer settings.
NOTE
While the device is being reset, the device and its functions are briefly unavailable.
Reset the device to factory settings
> Device > > Reset Factory settings > > Select option >
Parameter Value Factory setting
Reset Factory settings No
Yes
-
Resetting device to customer settings
> Device > > Reset Customer settings > > Select option
OPERATION 7
8026231/1I18/2023-01-05 | SICK O P E R A T I N G I N S T R U C T I O N S | OD2000
45
Subject to change without notice

SICK OD2000 Specifications

General

Brand	SICK
Model	OD2000
Category	Accessories
Language	English