SICK Ranger3

Parameter Type Description Visibility Access
EncoderValue int Reads the current value of the position counter of the
selected encoder.
Expert R
1
SNFC setting
Table 28: Encoder control standard SFNC command
Command Description Visibility Access
EncoderReset Resets the EncoderValue of the selected Encoder. The
Encoder starts counting events immediately after the
reset. EncoderReset can be used to reset the Encoder
independently from the EncoderResetSource.
Expert RW
16.2.8 Event control
Table 29: Event control standard SFNC selector
Selector Type Description Visibility
EventSelector enum Selects which Event to signal to the host application.
Value:
LogMessage
Expert
Table 30: Event control standard SFNC parameter
Parameter Type Description Visibility Access
EventNotification[EventSelector] enum Activate or deactivate the notification to the host appli‐
cation of the occurrence of the selected Event.
Values:
Off: The selected Event notification is disabled.
On: The selected Event notification is enabled.
Expert RW
16.2.9 User Set control
Table 31: User Set control standard SFNC selector
Selector Type Description Visibility
UserSetSelector enum Selects the feature User Set to load, save or configure.
Default User Set is read-only and cannot be modified.
Values:
Default
UserSet1
UserSet2
UserSet3
UserSet4
UserSet5
Beginner
Table 32: User Set control standard SFNC parameters
Parameter Type Description Visibility Access
UserSetDescription[UserSetSelec‐
tor]
string Description of the content of a User Set. Beginner RW
UserSetDefault[UserSetSelector] enum Selects the feature User Set to load and make active by
default when the device is reset.
Values:
Default
UserSet1
UserSet2
UserSet3
UserSet4
UserSet5
Beginner RW
16 ANNEX
104
O P E R A T I N G I N S T R U C T I O N S | Ranger3 8020774/1D7Q/2022-03 | SICK
Subject to change without notice