SICK Ranger3

NOTE
•
When saving a User File to the device, the original file name and file extension are
lost. The file is named "UserFile" on the device.
•
If the selected file is too large, no data will be written to the device.
To save a User File from a PC to the device:
1. Connect the PC to the camera.
2. On the Device menu in the GUI, click Device Files...
✓
The Device Files window opens.
3. On the UserFile row, click Send to camera.
4. In the file selection dialogue that appears, select a file and click Open.
✓
The file is now stored on the device.
To download a User File from the device to a PC:
1. Connect the PC to the camera.
2. On the Device menu, click Device Files...
✓
The Device Files window opens.
3. On the UserFile row, click Retrieve from camera.
4. In the "Save as..." dialogue that appears, select a file name and a file extension.
5. Select a directory on the PC and click Save.
✓
The file is now stored on the device.
9.2.6 Booting the device using a User Set
A User Set contains a full set of parameter values that can be used for booting the
camera. Up to five User Sets can be stored on the device.
The device can be programmed to boot from either one of the stored User Sets, or from
the built-in Default parameter values. If no User Set is selected, the Default option is
used.
To save a User Set:
1. Connect to the camera.
2. Open the Parameter editor.
3. Edit the parameter values for the User Set.
4. Select the User Set Control category.
5. In the User Set Selector list, select a User Set to use for storing the current parame‐
ter values.
6. Optionally, enter a description of the User Set in the User Set Description field.
7. Click UserSetSave to store the current parameter values in the selected User Set.
To boot from a User Set:
1. In the Parameter editor, select the User Set Control category.
2. In the User Set Default list, select the User Set that you want the device to boot from.
✓
Next time the device boots, it will use the parameter values in the selected User
Set.
To load a User Set:
1. In the Parameter editor, select the User Set Control category.
2. In the User Set Selector list, select a User Set.
3. Click UserSetLoad.
✓
The parameters in the selected User Set are now used on the device.
Migrating a User Set
Since the set of available camera parameters often changes when the camera firmware
is updated, a User Set is only valid for the firmware version that was used when
creating the User Set.
OPERATION 9
8020774/1D7Q/2022-03 | SICK O P E R A T I N G I N S T R U C T I O N S | Ranger3
59
Subject to change without notice