SICK Ranger3

Table 33: User Set control custom parameters
Parameter Type Description Visibility Access
UserSetFirmwareVersion[UserSet‐
Selector]
string The firmware version for which the configuration was
created. It is only possible to load user sets that are
created for the currently running firmware version.
Beginner R
Table 34: User Set control standard SFNC commands
Command Description Visibility Access
UserSetLoad[UserSetSelector] Loads the User Set specified by UserSetSelector from the
device's non-volatile memory and makes it active.
Beginner RW
UserSetSave[UserSetSelector] Saves the User Set specified by UserSetSelector to the
non-volatile memory of the device.
Beginner RW
Table 35: User Set control custom command
Command Description Visibility Access
UserSetDelete[UserSetSelector] Removes the User Set specified by UserSetSelector from
the device's non-volatile memory and makes it active.
Expert RW
16.2.10 File access control
Normally, the user must not edit these features. They are only used for firmware update.
Table 36: File access control standard SFNC selectors
Selector Type Description Visibility
FileSelector enum Selects the target file in the device.
Values:
UserSet1
UserSet2
UserSet3
UserSet4
UserSet5
Guru
FileOperationSelector enum Selects the target operation for the selected file in the
device. This operation is executed when the FileOperatio‐
nExecute feature is called.
Values:
Open
Close
Write
Read
Delete
Guru
Table 37: File access control standard SFNC parameters
Parameter Type Description Visibility Access
FileAccessOffset[FileSelector][Fil‐
eOperationSelector]
int Controls the Offset of the mapping between the device
file storage and the FileAccessBuffer.
Guru RW
FileAccessLength[FileSelec‐
tor][FileOperationSelector]
int Controls the Length of the mapping between the device
file storage and the FileAccessBuffer.
Guru RW
FileOperationStatus[FileSelec‐
tor][FileOperationSelector]
enum File operation execution status.
Values:
Success
Failure
Guru R
FileOperationResult[FileSelec‐
tor][FileOperationSelector]
int File operation result.
For Read or Write operations, the number of success‐
fully read/written bytes is returned.
Guru R
ANNEX 16
8020774/1D7Q/2022-03 | SICK O P E R A T I N G I N S T R U C T I O N S | Ranger3
105
Subject to change without notice