Starting and stopping the image acquisition
The Start and Stop buttons in the Parameter editor start and stop the image acquisition.
Use these buttons to control the image acquisition directly from the Parameter editor
during parameter adjustment.
9.1.3 Workflow steps
Figure 41: Workflow steps
The following workflow steps are available:
Start
In this step, you see the last connected device and reconnect to it.
Figure 42: Workflow step Start
Cameras
In this step, you search the network and see a list of all devices that are available. You
can select a device and connect or disconnect to it.
It is also possible to reconfigure the camera IP settings. This is useful for example
when you want to connect to a camera that is not on the same subnet as the NIC, see
"Recommended network card settings", page 110. Then you have to reconfigure the
camera to the same subnet, before you can connect to it.
9 OPERATION
52
O P E R A T I N G I N S T R U C T I O N S | Ranger3 8020774/1D7Q/2022-03 | SICK
Subject to change without notice
To Next Page
Loading...
