Statistics
The Statistics tab contains network statistics, such as lost data.
Figure 50: Statistics tab
9.1.7 General information
At the bottom of the screen, the following information is shown:
•
Model of the device
•
Name of the device (DeviceUserID)
•
IP address of the device
•
MAC address of the device
•
Serial number of the device
•
Software version
•
Frame ID of the image that is currently displayed.
NOTE
The frame ID is reset each time the camera is re-started.
9.2 Using the interface
9.2.1 Connecting and getting a 2D image
Workflow step: Start
The last connected device is displayed in the 'Quick connect' list together with a bar
indicating the device status:
Device is available (or already connected).
Device is available, but the IP settings need to be modified.
Device is already in use.
1. If the suggested device is correct and available, click Connect.
2. If the suggested device is not correct or if the IP settings need to be modified,
a) Click More devices to go to the Cameras workflow step.
b) Click Scan to see all devices that are available on the network.
c) Select the correct device.
d) If needed, click IP settings and edit the non-persistent IP settings of the
device, see "Editing IP settings", page 57.
e) Click Connect.
✓
When the device is connected, the Image workflow step is displayed and the
Parameter editor opens.
9 OPERATION
56
O P E R A T I N G I N S T R U C T I O N S | Ranger3 8020774/1D7Q/2022-03 | SICK
Subject to change without notice
To Next Page
Loading...
