SICK Ranger3

9.1.2 Parameter editor
Figure 39: Parameter editor button
Click the Parameter editor button in the user interface to open the Parameter editor. The
Parameter editor contains all the features that are available in the camera, sorted by
category (see "Features", page 92 for a full list of categories and features). To search
for a feature in the Parameter editor, use the search field in the upper left corner.
Figure 40: Parameter editor
Visibility options
The visibility options Beginner, Expert, and Guru define which features that are shown in
the Parameter editor. They are described in the table below.
Table 6: Visibility options
Beginner Basic features that are enough to operate the camera.
Expert In addition to the basic features, also features that require a more in-depth
knowledge of the camera functionality.
Guru All features that are available in the camera. This includes advanced fea‐
tures that can bring the camera into a state where it will not work properly
anymore.
Editing parameter values
Editable parameters have white input fields. Click an input field to edit its value. For
non-editable parameters, the input fields are inactivated and displayed in gray.
Most input fields are locked during image acquisition, which means that the parameter
values cannot be changed. When hovering over a locked input field, a warning message
appears. Click a locked input field to unlock it and stop the image acquisition.
OPERATION 9
8020774/1D7Q/2022-03 | SICK O P E R A T I N G I N S T R U C T I O N S | Ranger3
51
Subject to change without notice